Description - Have a motorcycle, but don't want to buy a full floor to park it on? Well, fret no more with our Diamond Nitro Tiles – Motorcycle Mats. These mats are made from our Nitro Tiles in pre-set colors. The mats contain tiles in varying colors with beveled edging around. Easy to install, clean, and maintain, these motorcycle mats are great for both commercial and residential use. These motorcycle mats are backed by a Limited Lifetime Warranty.
||4' x 8' and 5' x 10'
||0.62 lbs per tile
|Car Jack Approved
Kit Contents – Each 4' x 8' kit contains 32 of our 12" x 12" tiles, 12 Male Borders, 12 Female Borders, 4 Universal Corners. Each 5' x 10' kit contains 50 of our 12" x 12" tiles, 15 Male Borders, 15 Female Borders, 4 Universal Corners.
- These tiles can be damaged under the weight of a car jack. We recommend using your car jack directly on concrete or place a plywood board or steel plate under the jack.
- If your garage gets a lot of sun, we recommend placing vented tiles at the entrance to provide added stability to the floor.
- Nitro tile colors are produced in batches, which can lead to color variations in your order and affect color variation between samples and your order. All colors may present some color variation, and graphite and gunmetal can produce the most. These colors can vary greatly between batches, and we recommend that you order more flooring than needed for mistakes and replacements. This will give you the greatest chance to keep continuity across your floor.
Nitro interlocking tiles are easy to maintain. Cleaning of these multiuse tiles typically includes:
- Vacuuming or sweeping any loose crumbs, dust, or debris from the tiles when necessary.
- Hose off or damp mop the floor tiles with a mild soap and water mixture for tough or caked on dirt and/or stains.
Garage tiles are easy to install. Installation of these floor tiles typically includes:
- Clean your sub floor so that it is free of all dirt, dust, grease, or other foreign material.
- When installing the hard plastic tiles, we recommend starting in the front left corner of the room and working your way out from there.
- Make sure the female side (loops) of the tile is facing away from the wall.
- After filling the left wall with tiles and the adjacent wall, proceed to fill the rest of the room with whole tiles.
- When you come up to a wall or object, don’t worry. Just measure the area and cut the tiles with a tile cutter or a power saw with a fine-toothed blade and put the trimmed tiles into place.
- When trimming the tiles into place, make sure you leave about a 3/4” space between the tiles and the wall or obstruction.
- Once the tiles are in place, you can then snap in the edge pieces, if you purchased them.