Customer Questions
Don't see what you're looking for?
Are these weatherproof? I need them for entry into my garage from the driveway that has about ~1" lip.
Chelsea
Our 1/2" Rubber Floor Ramps are weather resistant. They are made from vinyl and would be able to withstand both freezing and scorching temps. We recommend when using these for this purpose that you glue the ramp down to keep it in place when coming in and out of your garage. You would want to use a polyurethane adhesive.
I'm looking for a ramp transition that can curve at a 6' radius, from 1/2" or 5/8" to 0". Can this product curve into a semicircle?
joanna
Our 1/2" Rubber Floor Ramps are pliable and can be made to curve into a semicircle. To keep them in place, we recommend gluing them in place once in the desired shape.
We just purchased foam back carpet tiles from your site. Would this transition piece work for that product? It's going from stained concrete into the workout room, and we need a transition piece. Thank you!
Maria Heady
Our foam backed carpet tiles are 5/8" thick, so our 1/2" Rubber Floor Ramps may not work the best for these products. We do offer a wide range of transition pieces on our trims and molding page that would work for both of your floors.
What adhesive should be used with this product when installed on concrete?
Earl D Cauthen
For our 1/2" Rubber Floor Ramps, you can adhere them to concrete with double-sided tape or with a pressure sensitive adhesive.
Would this work with the 1/2" eco soft foam flooring? We just installed that throughout our son's playroom but would like a reducer at the threshold, rather than the lip created by the current edge. Thanks!
Steve C
Our 1/2" Rubber Floor Ramps can be installed with our Eco-Soft + Tiles. To keep the ramp in place, we would recommend placing some glue under the base of the ramp.
How would the ramp be fixed to a 1/2" mega mat? How would the ramp be fixed to a low pile indoor/outdoor carpet?
To properly affix our 1/2" Rubber Floor Ramps to our flooring, we recommend adhering the ramp to the subfloor and then inserting the flooring into the ramp's groove. If you want to ensure the flooring stays in the ramp, you can use our Seam Sealer glue in the groove to keep the flooring in place. The same procedure would be used for indoor/outdoor carpeting.
How do you install this if one side of the door is rubber flooring and the other side is carpet? Does the rubber flooring go in the groove? How does the carpet stay on the other side?
When using our 1/2" Rubber Floor Ramps going down to carpet, you would put the rubber under the ramp, and the ramp tapered part would go over the carpet. If your rubber flooring and carpet are pretty much the same height, we recommend going with a T-Square trim. You can find proper trims on our Trims and Molding list page.
Will the 1/2" rubber floor ramp work with the 15mm rubber floor rolls? If not, do you have a ramp that will work with it? Thanks.
Valerie
Our 1/2" Rubber Floor Ramps are recommended to be used with flooring that is 1/2" thick. Our 15mm rubber flooring is a little thicker than this transition. If you were to use our 1/2" Rubber Floor Ramps with this thick of material, there would be a slight lip between the flooring the beginning of the ramp. Right now, we don't have a specific ramp that would work with our 15mm thick rubber flooring.
I want to transition from Shock Turf X to my floor without rubber tiles. Can I use this product?
You could use our 1/2" Rubber Floor Ramps with our Shock Turf X rolls. The height won't be the same, but you could butt the ramp up to the edge of the turf.
No results found.
1
...
...
